THIS PART REQUIRES WELDING AND GENERAL
FABRICATION SKILLS. ONLY COMPETENT WELDERS SHOULD ATTEMPT TO INSTALL THIS PART.
Tools Required :
Safety Glasses, Gloves, , Socket Set, Wrenches, Wheel
chocks, Cutting Tool of your choice
(Sawzall, Grinder, plasma, cutting torch)
Inventory that you have all of the parts for your order If you are missing
parts or have incorrect parts contact Artec Industries Immediately @
(855)-278-3299 M-F from 8am-5pm MST If it is after those hours please Email
Place wheel chocks at front wheels on vehicle , Jack up the rear of the vehicle and set securely
on jack stands .
Set TR8804 pinion bridge against the truss and mounting
flange on the axle. Bolt the flange to the axle if you are able to (Depending on your pinion angle you may need to trim the
bridge to fit) Weld the bridge
to the truss .
Raise vehicle and lower off of jack stands.
Check bolts for tightness after 50
miles re tighten if needed