DRILLING SERVICE FOR 60 HIGH STEER ARMS
This charge qualifies for ONE PAIR of arms and a SINGLE ARM is also the same price. FOR MULTIPLE PAIRS, ADD MULTIPLE QUANTITIES.
Choose from the following options for us to drill out your arms:
3/4 inch CROSSOVER STEERING hole. Use if you are going to use rod ends (heims) in your steering both for the drag link and tie rod. BLUE LOCATION on graphic below.
TRE CROSSOVER STEERING tapered hole. Use if you are going to use Tie Rod Ends (TRE) from GM/CHEVY used on 3/4 and 1 ton trucks. These are commonly referred to as "one ton" TREs and are basically a ball joint with a threaded shank. BLUE LOCATION on graphic below.
3/4 inch REID RACING knuckle bolt hole. THIS DRILLED HOLE IS ONLY AVAILABLE FOR REID RACING KNUCKLES. Due to the variance in Dana OEM manufacturing, the factory hole location can vary from knuckle to knuckle. Accordingly every knuckle bolt hole needs to drilled to the specific hole location of the knuckle it is attaching to. ONLY REID RACING KNUCKLES HAVE A PRECISE HOLE LOCATION EVERYTIME, AND THUS WE CAN ONLY DRILL FOR THAT KNUCKLE. RED LOCATION on graphic below.
DISCLAIMER: BY SELECTING 3/4 INCH REID RACING KNUCKLE BOLT HOLE OPTION, YOU CONFIRM THAT YOU ARE USING THESE ON REID RACING/DEDENBEAR KNUCKLES ONLY. ARTEC INDUSTRIES IS NOT RESPONSIBLE IF YOU SELECT THIS OPTION AND THE HOLE DOES NOT LINE UP TO ANY OTHER KNUCKLE OTHER THAN REID RACING KNUCKLES. NO RETURNS ON DRILLED ARMS.
**PLEASE ALLOW 7 - 10 WORKING DAYS FOR DRILLING SERVICES**