Kingpin Springless Conversion Cap
Rather than use the factory kingpin springs, the knuckle is held together with a springless design that uses a set screw to adjust the torque required to hold together. This eliminates some of the slop that is commonly found in axles that receive moderate offroad abuse. The hardware for a springless conversion is included and consists of a 3/4" set screw, jam nut, grease zerk, .250" thick load washer, and upper kingpin bushing for each arm.
CNC Laser cut and Machined from 3/4" thick steel
Springless design eliminates slop caused by preloaded spring
Springless hardware included
Grease zerk fitting for kingpin lubrication
4 bolt holes for use with OEM or Reid Racing Knuckles
1/2" fine thread Grade 8 bolts included
NOTE: This product requires general mechanics skills. Installation should only be done by a competent installer. Artec Industries implies no guarantees or warranties and is not liable for improper installation.